HA24-11 Contactor and Light Bulb
Multisim and Real Components           40 points
OEET 120

Back to Main Page
 
Multisim Portion of this Project
Connect the components shown below so that the switch controls the relay coil, and the relay contacts control the light.

Real-Component Portion of this Project
    1. Using the 3-phase terminals on a motor trainer base unit, and a contactor with a 120 V. coil, wire up a circuit that will have a 120 V. light bulb controlled by one set of  heavy-current contacts on the contactor. Instead of a switch to turn the relay coil on and off, simply touch a wire to one of the coil's terminals to turn it on. (Have the other coil terminal permanently connected.)
    2. Same as above, except use a contactor with a 208 V. or 240 V. coil.
 
Back to Main Page